Prototyping Accessories

Overview The imp004m module itself is preprogrammed with impOS, however, the WiFi firmware lives on an external SPI flash chip, which must be preloaded with the applicable WiFi firmware. SPI flash sizes between 8Mbit (1MByte) and 128Mbit (16MByte) are supported.  Developers without the capability to load th...
Overview The imp004m module itself is preprogrammed with impOS, however, the WiFi firmware lives on an extern...
$5.00
Overview Serial flash pre-programmed with impOS for the imp005. The imp005 requires an external 32 to 64Mbit SPI flash to be programmed with the impOS image, which is available for download from the Electric Imp website. Developers without the capability to load the image to the Serial flash can purchase these 64Mbit Cypress S25FL064LABMI010 (S...
Overview Serial flash pre-programmed with impOS for the imp005. The imp005 requires an external 32 to 64Mbit SPI flash to be programmed with the i...
$5.00
Overview This cable adapts from the RJ12 connector on the Battery Powered Sensor Node to individual pins suitable for inserting into breadboards and common pin headers. This allows the Battery Powered Sensor Node to be easily interfaced to additional devices and sensors with i2c, UART or 1-wire interfaces. Warning: The wire colors do not fol...
Overview This cable adapts from the RJ12 connector on the Battery Powered Sensor Node to individual pins suitable for inserting into breadboards a...
$8.00
Overview Enables customers who need to perform RF testing on imp003 based products - for example, for CE testing or approvals which are not covered by the existing FCC/IC modular certification (eg alternate antennas) - to do so. The kit contains a custom imp003 module loaded with the Cypress RF test image which needs to be mounted in the produc...
Overview Enables customers who need to perform RF testing on imp003 based products - for example, for CE testing or approvals which are not covere...
$50.00
Enables customers who cannot use the Murata FCC modular certification to control radio modes for their own testing. Control is handled by the imp005 (module loaded with custom test firmware + SPI flash) via the UART using the included FTDI cable from a laptop or computer. A certifying testing lab should be familiar with this configuration for c...
Enables customers who cannot use the Murata FCC modular certification to control radio modes for their own testing. Control is handled by the imp0...
$50.00
Overview Developers without the capability to program Serial flash can purchase these 64Mbit Cypress S25FL064LABMI010 (SOIC-8) devices for use in their designs. The S25FL064L can be used with the imp003/imp004m and imp005 devices. Please consult the datasheet of each imp device for other recommended memory devices Note: the flash must be progra...
Overview Developers without the capability to program Serial flash can purchase these 64Mbit Cypress S25FL064LABMI010 (SOIC-8) devices for use in ...
$185.00

1 – 6 products of 6